Device Reset (Reset); Settings - Silvercrest SAB 160 B2 Operating Instructions Manual

Device reset (RESET)

GB
IE

Settings

Volume
Loudness
Switching mute on and off
14
To reset the device to its factory default settings, press the RESET button
a pointed object, such as a pen.
NOTE
► To access the RESET button, the control panel must be completely removed
(see also Section "Removing the control panel").
► If a reset does not correct the fault, please contact our Service department
(contact information see guarantee card).
Reset the device:
▯ when using it for the fi rst time,
▯ after connecting the cables,
▯ if not all function buttons are working,
▯ if an error message is shown on the display,
▯ if there is an obvious malfunction in the device.
WARNING
Excessive volume can cause hearing damage!
Setting the volume too high can result in permanent hearing damage.
► Set the volume to moderate levels only.
♦ Turn the multi-controller
♦ Hold down the MD/LD button
LOUD ON or LOUD OFF appears on the display.
Press the
♦ /
display.
♦ Press the /
celled when receiving a PTY or TA station or if you change station or source.
3 to set the volume.
to switch the loudness function on or off .
5
button to switch the sound off . "MUTE" fl ashes on the
19
button again to turn the sound on again. Muting is can-
with
23
SAB 160 B2