Remote Slab Sensor
temperature sensor. Any firmware version may be used to operate the
CHV-RSS as an outdoor temperature sensor.
NOTE: If the maximum number of sensors is exceeded, some of the
sensors will be ignored by the system.
NOTE: The CHV-RTHS counts as two sensors because it measures both
temperature and humidity.
Specifications
SPECIFICATION
Temperature Range
Accuracy
Wiring
*Thermostat front panel indoor temperature display is limited to a range
of 0 to 110º F (-18º to 43º C). The front panel outdoor thermostat display
will display the full range of temperature.
Physical Description
Refer to the illustrations below and on the following page.
The sensor has a diameter of 0.32 inch (7.92 mm) and is 2.75 inches
(6.98 cm) long.
The CHV-RSS remote sensor is contained in a cylindrical stainless steel
housing.
CHV-RSS
NOTE: The sensor determines the temperature using the entire surface of
its steel housing. Do not mount the sensor where only a portion of the
housing is exposed to the environment.
2 • Remote Slab Sensor: CHV-RSS
Crestron CHV-RSS
DETAILS
-40º to 170º F (-40º to 77º C)*
1º F (0.5º C)
Two non-polarized wires
Installation Guide – DOC. 6229A