The Current Sensor for CNTV, CNTV-CS, senses whether a single television set (9” color or larger) is OFF or ON. The CNTV-CS senses the current used by the television that is connected to it, a large current indicates that the set is ON and the absence of (or very low) current indicates that the set is OFF.
Setup Digital Connector Wiring The digital connector of the CNTV-CS provides the current sense to the CNTV (or other Cresnet processor). The black wire of the CNTV-CS cord must be attached to pin-5 (G or ground pin) of the connector and the black with white-stripe wire may be attached to either pin-1, 2, 3, or 4.
Digital Connector Wiring Hookup Refer to the two diagrams after this paragraph. The CNTV-CS should be plugged into an AC outlet and the television to be current sensed is plugged into the CNTV-CS. The digital connector of the CNTV-CS is attached to the DIGITAL IN/OUT back panel connector of the CNTV.
Current Sensor for CNTV Programming The CNTV-CS does not require programming. The program of the CNTV determines how the digital input from the CNTV-CS is recognized. Refer to CNTV Operations Guide (latest revision of Doc. 8105) for further information. Problem Solving...
(3) years from the date of shipment to purchaser. Disk drives and any other moving or rotating mechanical parts are covered for a period of one (1) year. CRESTRON warrants all its other products for a period of one year from the defects mentioned above, excluding touchscreen display components which are covered for 90 days.