Table of Contents
Advertisement
Remote Slab Sensor
Refer to the following illustration.
NOTE: Sensor should not come in contact with metal objects.
Suggested Mounting Illustration
Coaxial Cable
Standoff
Feedthrough
Bushing
8 • Remote Slab Sensor: CHV-RSS
1. Mount the sensor using two coaxial cable standoffs. If the fit is
not snug, use silicon adhesive to secure the sensor in place.
2. Use a plastic feedthrough bushing and pass the wires through the
outside wall.
3. Form a drip loop in the wire to prevent moisture from entering
the building.
Silicon Adhesive
CHV-RSS
Coaxial
Cable
Standoffs
Twisted Pair
Feedthrough
Bushing
Drip Loop
Installation Guide – DOC. 6229A
Crestron CHV-RSS
Outside Wall
Advertisement
Table of Contents
