Identity Code - Crestron C2N-SDC-DC Operations & Installation Manual

Shade & Drape DC Motor Controller

Identity Code

Every piece of equipment and user interface within the network requires
a unique identity code (Net ID or Cresnet ID). These codes are two-digit
hexadecimal numbers from 03 to FE (ID 02 is reserved for control
systems). The Net ID of each unit must match an ID code specified in the
SIMPL Windows program.
The Net ID of the C2N-SDC-DC has been factory set to 23. The Net IDs
of multiple C2N-SDC-DCs in the same system must be unique. Net IDs
are changed from a personal computer (PC) via Crestron Toolbox.
NOTE: If communication cannot be established, refer to the
"Troubleshooting Communications" section in the 2-Series Control
Systems Reference Guide (latest version of Doc. 6256) for details. If an
earlier control system is used, refer to the latest version of that control
system's Operation Guide.
NOTE: This method does not change the Net ID as assigned in SIMPL
windows.
8 Shade & Drape DC Motor Controller: C2N-SDC-DC
1. Ensure that the C2N-SDC-DC is connected to your computer
through a control system. Refer to "Communication Settings"
on page 18.
2. Once communication is established, click Tools | Network
Device Tree to display the devices in the system.
Communications are confirmed when the network devices are
displayed.
Network Device Tree
Crestron C2N-SDC-DC
Operations & Installation Guide - DOC. 6373