Table of Contents
Advertisement
Digital Video Processor
Compiling and Uploading a Program to the Control
System
34 • Digital Video Processor: C2N-DVP4DI
Cable Connection for Programming
Cable Hardware
•
DB9 RS-232 Cable (male/female, straight-through)
•
RJ45 10/100 BaseT Ethernet Cable
•
Cresnet Cable (for power)
The C2N-DVP4DI may be programmed using the compact flash with the program
already written to it, or by downloading the program via serial cable or via Ethernet
cable. Refer to "Network Wiring" in the latest version of the latest version of the
C2N-DVP4DI Reference Guide (Doc. 6177), available from the Crestron website
(www.crestron.com) when making network connections. The following is for cable
connections only. Refer to "Establishing Communication with the Control System"
on page 10 for typical connections.
NOTE: The C2N-DVP4DI only accepts programming in the master mode.
1. Ensure that 75 watts of power is available at the Cresnet port.
2. If programming using RS-232, attach the RS-232 cable to the COMPUTER
port and an available computer COM port of the PC. Refer to "Establishing
Communication with the Control System" on page 10.
3. If programming using Ethernet, attach the Ethernet cable to the LAN port
and the Ethernet port of the PC. Refer to "TCP/IP Connection" on page 12.
Compile and Upload Programming
After you have completed your SIMPL Windows program you must compile and
upload the program to the control system.
To compile the program, simply click the Convert/Compile button
SIMPL Windows toolbar, or select Project | Convert/Compile (you can also press
F12). A status bar will indicate the progress of the compile operation. After the
operation is complete, a window will display information about the program such as
the number and type of signals, and memory usage.
The compiled program will be stored as an SPZ file in the same directory as the
source file. There are several ways to upload an SPZ file to the control system.
Immediately after compiling the program you are prompted to transfer the file to the
control system.
Click the Transfer button
Program" window (refer to the following graphic). Click Browse, locate the SPZ file
and click Open. This will display the program header information and enable one or
both of the What to Send check boxes. If the program does not contain any SIMPL+
modules only the SIMPL Program check box will be enabled. If it does contain
SIMPL+ modules, then the SIMPL+ check box will also be enabled. Select one or
both check boxes and then click Send Program to begin the transfer.
Crestron C2N-DVP4DI
on the SIMPL Windows toolbar to open the "Send
Operations Guide – DOC. 6112
on the
Advertisement
Table of Contents
