Table of Contents
Advertisement
Crestron C2N-DVP4DI
Configuration
Master/Slave Mode Setup
Video Output Setup
RGB Video Input Adjustment
Operations Guide – DOC. 6112
8. Open Viewport and establish communications with the C2N-DVP4DI (refer
to page 10, "Serial Connection" for more information).
9. Type output at the C2N-DVP4DI prompt in Viewport and press Enter to
view the current resolution setting. Refer to page 23.
10. Set the output resolution of the C2N-DVP4DI in Viewport to match the
native resolution of the display device.
Refer to "Interface Menu" on page 15.
11. Open the MAIN MENU using the touchscreen, select Setup under System.
12. Select Interface.
13. Select MASTER or SLAVE (Cresnet ID change required if in Cresnet
slave mode. IP table entry required for Ethernet slave mode).
Perform output setting before adjusting input. Refer to page 20.
14. Open the MAIN MENU using the touchscreen.
15. Select RGB and Video SETUP under DVI, RGB and Video startup options.
16. Select Check Output.
17. Select Grid and the project/display device. Adjust the grid as needed using
a grid test pattern to fill the screen.
18. Select Vertical Lines, adjust coarse or clock on the projector/display
device, then phase or fine.
19. Custom resolution is set in Viewport.
Refer to page 25 (requires a video diagnostic program or pattern generator installed
on the PC).
20. Select RGB and Video SETUP from the MAIN MENU.
21. Choose Select Input.
22. Select an RGB source (1-4).
23. Open a video diagnostic program on the RGB source.
24. Display a grid on the RGB source. Adjust to fill the screen.
25. Select a Vertical line pattern from a video diagnostic program. Display a
test pattern of vertical lines (similar to video output vertical lines).
26. Adjust coarse setting as desired.
27. Adjust fine setting as desired.
Digital Video Processor
Digital Video Processor: C2N-DVP4DI • 7
Advertisement
Table of Contents
