Table of Contents
Advertisement
Crestron C2N-DVP4DI
Operations Guide – DOC. 6112
Page Flip (Page B changing position only)
Page A
Page B
The C2N-DVP4DI uses either the default timing or analog value from VT
Pro-e for the duration of the on-screen to on-screen transition. Duration is
not set in this menu.
The on-screen to on-screen effect applies to all sources (RGB, DVI, S-
video, component video, and composite video).
For the new size and position option to operate, the vertical frequency of the
RGB sources must be the same as the C2N-DVP4DI output vertical
frequency. Otherwise the C2N-DVP4DI defaults to the fade down/fade up
effect, overriding the SETUP | OPTION setting.
Video sources are scaled to the C2N-DVP4DI output resolution and
frequency so they will allow the stretch effect to work.
The Default Video buttons (NTSC and PAL) permit a choice of which kind of video
is searched for first, and works for both composite and S-video. For example: If
NTSC is selected, the C2N-DVP4DI searches for NTSC first, and then searches for
PAL.
Translucent Objects
This MAIN MENU TRANSLUCENT OBJECTS option allows the user to change
the translucency of displayed buttons. The default is 50% transparent. 100% is
invisible, 0% is opaque (refer to following graphic).
NOTE: Setup screens are always displayed as 800 x 600. When the buttons are full
off (100% transparent), pressing anywhere within this 800 x 600 setup page returns
the buttons to 50% translucency. This disappearing button feature is very useful
when fine-tuning color, size, etc.
Translucency
Digital Video Processor
Page A
Page B
Digital Video Processor: C2N-DVP4DI • 33
Advertisement
Table of Contents
