Table of Contents
Advertisement
Digital Video Processor
26 • Digital Video Processor: C2N-DVP4DI
NOTE: Auto Calibration is not available for DVI sources. Use default calibration
for DVI sources.
Calibration Adjustments Using Viewport
Auto calibrate, default calibrate, no overscan, and lock calibration are also accessed
through Viewport using the input command. Type input at the prompt to display all
connected inputs to the C2N-DVP4DI:
DVP4DI>input
Input RGB 1 Default Horizontal Resolution:
Input RGB 2 no signal present.
Input RGB 3 Default Horizontal Resolution:
Input RGB 4 Default Horizontal Resolution:
Type input ? to access the input adjustments:
DVP4DI>input ?
Format is "INPUT 1 2", where Parameter 1 is 1,
2, 3, or 4 to select one of the four RGB inputs,
and Parameter 2 is the new Horizontal
Resolution, from 320 to 1920,
or "A" to Auto Calibrate this input,
or "D" for Default for this input,
or "N" for No HDTV Overscan for this input,
or "L" to Lock Auto Calibrate On for this input.
For example: Typing: input 1 L locks auto calibrate for RGB source 1.
If this selection does not look correct, select Default Calibration or manually set the
parameters as described in this manual.
Default Calibration sets the input setting to the factory defaults. If AUTO
Calibrate or Default Calibration settings are not perfect, continue with the
following steps.
NOTE: If you are unable to obtain a stable RGB window, perform the Lock Sync
adjustment before continuing with the color, size and position adjustments.
RGB Position Adjustment
Select a vertical/horizontal line grid to display in RGB window, and select Position.
The position buttons appear (refer to the following graphics).
Position Buttons
Crestron C2N-DVP4DI
640
1280
1024
Operations Guide – DOC. 6112
Advertisement
Table of Contents
