Interface Menu - Crestron C2N-DVP4DI Operation Manual

Crestron C2N-DVP4DI
IP Table Setup for Ethernet Slave Mode
Operations Guide – DOC. 6112
"Programming with SIMPL Windows" in the latest version of the C2N-DVP4DI
Reference Guide (Doc. 6177), available from the Crestron website
(www.crestron.com).

Interface Menu

The INTERFACE MENU is a submenu of the SYSTEM SETUP MENU. The C2N-
DVP4DI communicates with a control system to activate other controls or to display
feedback from components within the system. The INTERFACE MENU (refer to the
illustration on page 17) allows you to set the correct Cresnet ID to communicate with
a control system or other Cresnet devices. The INTERFACE MENU also allows you
to select master mode, Ethernet slave mode, or Cresnet slave mode. Use master
mode when you want the C2N-DVP4DI to operate as a stand-alone control system.
Use the slave mode when you want a control system to operate and control the C2N-
DVP4DI via Cresnet.
The CRESNET ID is a two-digit hexadecimal number. This number can range from
02 to FE and must correspond to the NET ID set in the SIMPL Windows program of
the Cresnet system. Matching IDs between the C2N-DVP4DI and SIMPL Windows
program is required if data is to be successfully transferred. NET ID is factory set to
54 in Cresnet slave mode. Two side-by-side buttons beneath the hexadecimal
display, DOWN and UP, decrease and increase the ID by one, respectively.
•
To set the master mode, select MASTER. This sets and locks the NET ID
to 02.
•
To set the Cresnet (CSLAVE) slave mode, select SLAVE and set the
Cresnet ID to a number from 03 to FE.
•
To set the Ethernet (ESLAVE) slave mode, select MASTER. This sets and
locks the NET ID to 02, then setup the IP table (refer to the following
directions).
1. Refer to "Ethernet Setup (Master/Slave Mode)" in the latest version of the
C2N-DVP4DI Reference Guide (Doc. 6177), available from the Crestron
website (www.crestron.com) and set the IP address and IP Mask for
network operation.
2. In Viewport, select Functions | Set up IP Table.
NOTE: If you are in Cresnet Slave mode, you will not be able to enter Ethernet
Slave mode. Cresnet slave mode overrides Ethernet slave mode.
NOTE: The IP address and IP mask must be assigned to the C2N-DVP4DI for the IP
table to function.
Digital Video Processor
Digital Video Processor: C2N-DVP4DI • 15