Crestron C2N-DVP4DI Operation Manual page 17

Crestron C2N-DVP4DI
Operations Guide – DOC. 6112
NOTE: Due to the complexities of the C2N-DVP4DI, it may take approximately 25
seconds to reboot.
NOTE: Throughout this manual, the phrase "Video Source" means all of the
following: S-video, composite video, component video, RGB, or DVI sources, unless
otherwise specified.
The following are the configuration prerequisites:
•
Display device connected to the output DVI/RGB port. If display connector
is VGA, 15-pin, use the supplied DVI-I/RGB adapter.
•
Minimum of one video input, connected to the input DVI/RGB, S-video,
composite, or component port. If the video source connector is VGA, 15-
pin, use the supplied DVI-I/RGB adapter.
•
Cresnet power (from Cresnet power supply) connected to the Cresnet port.
•
A touchscreen and a serial mouse connected to the touchscreen/mouse port
are required to use the setup screens.
•
Test pattern screens (third party application): Color bar, grid, gray scale and
vertical line pattern test screens.
•
PC connected to the C2N-DVP4DI with Viewport open.
Open the MAIN MENU by doing one of the following:
1. While the C2N-DVP4DI is powering up, hold down the left mouse button,
or with a touchscreen, hold a finger to the touchscreen until the MAIN
MENU screen opens (If using a mouse, the mouse must be moved while the
C2N-DVP4DI is starting).
2. If the compact flash is not installed or the installed compact flash is blank,
you will be prompted to touch (or click with a cursor) the screen to open the
MAIN MENU.
3. If the compact flash is installed with a loaded program, open Viewport,
connect to the C2N-DVP4DI (refer to "Establishing Communication with
the C2N-DVP4DI" on page 10) and type setup at the DVP4> (master)
prompt, CSLAVE_DVP4DI> (slave) prompt, or ESLAVE_DVP4DI>
(Ethernet slave) prompt.
Main Menu
Digital Video Processor
Digital Video Processor: C2N-DVP4DI • 13