Hart Address (Slave Address): Set; Test Run - AUMA SAEx 07.2 Manual

SAEx 07.2 SAEx 16.2/SAREx 07.2
ACExC 01.2 Non-Intrusive HART
10.4.

HART address (slave address): set

Select main menu
Set HART address
10.5.

Test run

SAREx 16.2 Control unit: electronic (MWG)
HART address adaptation is only required for multidrop operation. Without multidrop
operation, address 0 must be set.
Customer settings M0041
HART M1238
Address M1253
Default value: 0
Setting range: 0 63
1. Set selector switch to position 0 (OFF).
2. Press push button C Setup and hold it down for approx. 3 seconds.
Display goes to main menu and indicates: ▶ Display
3. Select parameter either:
(by clicking through the menu)
or press
Display indicates: Address
4. Press Ok.
Display shows the set address.
5. The bottom row of the display indicates:
Edit→ continue with step 6
Up ▲ Down ▼ → continue with step 10
6. Press Edit.
Display indicates: Observer (1)
7.
Select access level via
black triangle: ▶ = current setting
white triangle: ▷ = selection (not yet saved)
Information: Required access level: Specialist (4) or higher
8. Press Ok.
Display indicates: Password 0***
9.
Enter password (→ enter password).
Display shows the set address.
10. Enter new address via
Information: The address range is displayed in round brackets on the screen.
11. Confirm selection via
The HART address setting is complete.
Only perform test run only once all settings previously described have been
performed.
The direction of rotation can be checked at the position indicator if available. (Chapter
<Direction of rotation at mechanical position indicator: check>)
The direction of rotation must be checked at the hollow shaft/stem if no mechanical
position indicator is available. (Chapter <Direction of rotation at hollow shaft/stem:
check>)
and enter ID M0098 (direct selection)
Up ▲ Down ▼ resulting in the following significations:
Up ▲ Down ▼.
Save.
Commissioning (basic settings)
67