WEEDO F150S User Manual page 9

In the settings box below the advanced settings menu, there are four settings, namely "dual
extrusion", "warping prevention", "seam" and "others".
3.2.1、"Speed" interface:
Top/bottom speed (mm/s): the printing speed of the upper and bottom surfaces of the model.
Outer shell speed (mm/s): the printing speed of the model shell.
Inner shell speed (mm/s): the printing speed of the shell in the model.
Infill speed (mm/s): the speed of infilling inside the printing model.
Support infill speed (mm/s): the printing speed of model support infilling;
Supporting interface speed (mm/s): the printing speed of the upper and lower surfaces of the
model support.
Initial layer speed (mm/s): the printing speed of the first layer of the model.
Travel speed (mm/s): the movement speed of the nozzle without entering the printing state.
The above parameter will be changed automatically when users change the speed in the basic
interface, so it is generally not necessary to change these parameter; If the speed of some parts is
specified, it can be set separately according to the demand.
3.2.2、"Infill"interface:
Infill pattern: the filling mode inside the model, the user can change the filling mode according to
the requirements of the intensity and beauty of the model to be printed, that is, to change the
filling shape inside the print model.
Click the "infill pattern" drop-down menu to select the filling mode, including lines, grid, triangle, zig
9