WEEDO F150S User Manual page 35

Loose the screw and unplug the nozzle.
Completely unscrew the two hexagon socket head cap screw at right side,and take out fan and cooling fan.
Use a tweezers to clean the filament debris on the motor gear, and installation process is performed according
reverse procedures after cleaning.
Note:Finally plug in the motor connection cable.
9. Frequently Asked Questions and Troubleshooting (FAQ)
1. Will the wire replacement script be running for every booting?
The wire replacement script will not run for every booting; it is only running when the wire is replaced.
2. Can the finished model be picked up by hand immediately after the printing?
Please do not hand pick the model immediately, but wait for a moment to cool the model, and then gently shovel
the model with a spatula; be careful to not damage the blue 3M sticker on the printing platform.
3. What if the power light is off?
Please check the power switch at the front and the back, as well as the connection of the power cord at the back.
35