Print The First Model; Connect The Power Supply; Loading The Filament - WEEDO F150S User Manual

As shown above, all the parameters in the "advanced function" are changed, and then click the
"apply" and "OK" to complete all the settings.

4. Print the first model

4.1. Connect the power supply

Take out the power cord from the accessory box, insert it the power socket on the left side of the
printer and start the printer.

4.2 Loading the filament

Place the filament on the filament tray inside the printer.
Insert one end of the filament through the detection module in the printer chassis until it comes out
of the other end of the material pipe. Pull out the filament out of the material pipe about 20cm, use
right hand to press the extruder handle, and use left hand to insert the filament into the extruder
for about 5cm depth.
22