WEEDO F150S User Manual page 14

Retract at layer change: that is to say, the nozzle will turn on the retraction setting when printing
different layers of the model.
Retraction speed (mm/s): that is, the retraction speed of the nozzle, which is usually set by default.
Retraction distance（mm）：that is, the amount of material returned by the nozzle, which is usually
set by default.
Z hop height（mm）：that is to say, when the nozzle returns material, the lifting amount of the
nozzle , which is usually set by default.
Retraction Minimum travel （mm） ： that is, the nozzle movement distance before printing and before
the nozzle retracting filaments, which is usually set by default.
3.2.6、"Material" interface:
Filament flow（%）：that is, the flow rate of the consumables in the melting state,it is set according
to the consumable material. In general, the flow rate of PLA and PLA Pro is set to 90, and the flow
rate of ABS is set to 100.
Filament diameter （ mm） ： that is, the diameter of the consumable material, according to the nozzle
diameter used by the printer and the line diameter of the consumable material, the diameter of the
consumable material of the WEEDO series printer is 1.75mm at present.
Automatic change temperature： when printing, the nozzle will automatically change the printing
temperature according to the temperature characteristics of the consumables, the general
consumables are set by default, no need to select.
3.2.7、"Travel" interface:
14