WEEDO F150S User Manual page 17

Standby temperature: that is when a double nozzle machine is printing, one of the nozzles stays at
the temperature waiting to be printed.
Prime tower: when the double nozzle model is printed, one of the nozzles is waiting to be printed.
The residual temperature of the nozzle leads to the overflow of the consumable material from the
nozzle. The erasing tower can erase the spillover of the nozzle, which is located on the side of the
print model, that is, the length of the side length of the waiting nozzle printing and erasing tower.
Ooze shield distance: when a double nozzle is printed, one of the nozzles is waiting to be printed.
The residual temperature of the nozzle leads to the overflow of the nozzle from the nozzle or
prevents the print head from touching the model and damages the model surface. Therefore, a
circle of protection layers is printed on the edge of the model, which refers to the protection layer
and the mode's distance.
Support extruder, support interface extruder, build plate adhesion extruder and infill extruder: that
is to set up the printing support, the support surface, the bottom plate and the filled nozzle. In
general, the main part of the printing is the right head, which is generally set by default.
3.2.11、"Warping prevention" interface:
When printing a large model, the model can not be stuck well and easy to warping edge.
Parameters can be set under this column to prevent warping; there are three main ways:
17