WEEDO F150S User Manual page 36

4. What if the computer software cannot be connected to the printer?
Please check whether the USB interface is connected properly; turn off the ReplicatorG software on your
computer and try printing again;
If it does not work, please restart the computer and the printer.
5. What if the bottom of the printed model cannot stand firmly or the model moves?
Please check the set temperature of the printing platform is correct or not; whether the printing platform has
reached the set temperature.
If the temperature of the printing platform is correct, please check the printing platform (heating plate) is smooth
or not, and adjust the printing platform.
6. What if the printing Nozzle is clogged or the wire would not come out of the Nozzle?
Please check whether the feed wire on the feeding rack has run out.
1) feed wire runs out, indicating that there is feed wire segment left in the printing Nozzle.
Please remove the fan at the top of the printing Nozzle, remove the printing Nozzle, and then heat the printing
Nozzle to 230 ℃ and carefully pull out the feed wire using pliers. Turn off the printer and reinstall the printing
Nozzle when it is cool.
2) The feed wire does not run out, indicating that the print Nozzle is clogged. Remove the fan above the printing
Nozzle to see whether the feeding gear is wound with the feed wire. If the wire is wound there, cut the wire from
the top of the aluminum block, remove the printing Nozzle; then heat the print Nozzle to 230 ℃, carefully pull off
the feed wire section with pliers and remove the Nozzle at the same time; clean up the feed wire and debris in the
feeding gear, turn off the printer and install the Nozzle and the printing Nozzle; if there is no wound fire, please
heat the printing Nozzle to 230 ℃, press the extrusion handle to feed the wire manually; push the wire a little
harder to push out the wire section left in the Nozzle, and then pull out the wire manually, and then push the feed
wire manually; repeat this process several times until the printing Nozzle is completely clear and clean.
Please be careful to clear the print extruders and avoid scald.
If the printing nozzle cannot be cleaned, please contact our company to replace the nozzle. After changing the
print nozzles, please readjust the platform before printing.
36