WEEDO F150S User Manual page 18

Z axis offset: when the Z axis bias is changed to negative, the gap between the model and
1
the print base plate is reduced, so that the model and the printing plate are pasted more
tightly to prevent the warping.
The extra contour of the surface layer is to increase the number of contour in the outer
2
contour of the surface of the model and the printed plate, so that the contact surface of
the model bottom and the print floor is greater, so as to prevent the warping edge.
○
3 the initial layer temperature increment: that is to set the model to print the first layer
temperature higher than the later printing temperature, and the high temperature will make the
bottom layer of the model stick more firmly and prevent the warping edge.
After changing the parameters, the printing results of the above models are as follows:
3.2.12、"Seams" interface:
18