WEEDO F150S User Manual page 16

Outer Wall Line Width(mm): Width of the outermost wall line. By lowering this value, higher levels
of detail can be printed.
Inner Wall(s) Line Width(mm):Width of a single wall line for all wall lines except the outermost one.
Top/bottom Surface Skin Line Width(mm): Width of a single top/bottom line.
Infill Line Width(mm): Width of a single infill line.
Support Line Width(mm): Width of a single support structure line.
Skirt/Brim Line Width(mm):Width of a single skirt or brim line.
Raft Top Line Width(mm): Width of the lines in the top surface of the raft. These can be thin lines so
that the top of the raft becomes smooth.
Raft Middle Line Width(mm): Width of the lines in the middle raft layer. Making the second layer
extrude more causes the lines to stick to the build plate.
Raft Base Line Width(mm):Width of the lines in the base raft layer. These should be thick lines to
assist in build plate adhesion.
3.2.10、"Double nozzle" interface：
The interface is the parameter setting of WEEDO double nozzle series.
16