Installing The Support Rack; Aligning The Unit; Aligning Countertop Unit; Aligning A Floor-Standing Unit - Henny Penny FlexFusion FPE-615 Installation Manual

Installing the unit

5.4.1 Installing the support rack

Prerequisite Pins installed in the uprights of the base frame

5.5 Aligning the unit

5.5.1 Aligning countertop unit

Prerequisite Base frame levelled

5.5.2 Aligning a floor-standing unit

NOTICE
INFORMATION
20
Depending on the version, the base frame can be equipped with a
hang-in frame.
The hang-in the frame is used to hold containers, baking sheets and
grates.
A
a
Image: A Stop profile, B Hang-in frame
a Stop profile
b Bolt
1. Place the stop profiles on the pins (at the back).
2. Install the support racks.
Level the unit by screwing the equipment legs in or out.
Fill out the Start-up operation report.
Risk of water discharge from leaking cooking chamber
The cooking chamber will leak if the tray trolley is not aligned.
• Operate a floor-standing unit only with the tray trolley.
• Align the tray trolley carefully.
The tray trolley is needed to align a floor-standing unit.
Prepare the tray trolley.
Installation instructions
B
b
c
c Outboard support rack
d Inboard support rack
d
c