Expansion Cards - DEGA UDA III User Manual

6.11.11 Expansion cards

Settings of individual expansion cards UDA III RE16 and UDA III AI8
UDA III RE16
- Label - user label
- Outputs and RE1-RE16 - Setting of individual output relays. Same logic as for the control panel relay. See chapter 9.11.12
- Relay test - manual relay test. Same logic as the control panel relay. See chapter 11/9/18
- Default - clears the output configuration matrix from all transmitters
- Load - loads the output configuration matrix from the card
- Delete - deletes the card from the control panel configuration
Outputs from a maximum of 32 transmitters can be set for each relay card
UDA III AI8
- Label - user label
- Channel -> address - virtual RS485 address of the connected analog transmitter
- HART - activation of the HART protocol on the given input
- Default - clears the output configuration matrix from all transmitters
- Load - loads the output configuration matrix from the card
- Delete - deletes the card from the control panel configuration
Figure 51 Expansion cards
59