Table of Contents
Advertisement
Transmitters tab
The basic screen of the control panel where the status and values of individual channels are displayed. Each channel is
represented by a graphic element with a description (location) of the transmitter and the measured value. 12 transmitters are
displayed on one page, you can switch between the pages using the navigation buttons. A channel is an active element that,
when pressed, brings up the channel details screen.
Measured value
indicator
Item
Channel number
Transmitter type
Transmitter address
User label
Channel value
Detected gas
Channel value
indicator
Channel status
Table 8 Control panel channel
Transmitter
Channel
Measured value of
channel + units
Figure 28 Control panel channel
Description
Channel number [1-250]
Type designation of the connected transmitter
Transmitter address on the bus.
User-defined label is used to identify/mark the position of the transmitter in the installation. The
label can be changed in the channel details screen.
Measured channel value including units
Identification of the detected substance, usually gas
Measured value indicator in relation to alarm level 4. Value 0 corresponds to the idle
concentration of the channel, value 100% (full range) corresponds to the value for alarm 4.
Details are described in the following chapter.
Figure 27 Transmitter tab
Detected
gas
39
Transmitter
address on the bus
Custom channel
label
Channel
status
Advertisement
Table of Contents
