Ups - DEGA UDA III User Manual

6.11.3 UPS

The dialog is used to configure the UPS. The sensor channel value is the measured UPS battery voltage [V]. Furthermore, the
control panel evaluates the UPS status signals and can be responded to by activating a channel alarm.
Dialog item
Description
Alarm1
Alarm2
Alarm3
Alarm4
Show channel
Outputs
Table 21 Dialog UPS
The channel signals for the output response matrix are as follows:
Signal name Description
Alarm1 Activation of any of the selected UPS signals will trigger the appropriate alarm
Alarm2 Activation of any of the selected UPS signals will trigger the appropriate alarm
Alarm3 Activation of any of the selected UPS signals will trigger the appropriate alarm
Alarm4 A UPS voltage value lower than the set value triggers the Alarm4 signal
PEL alarm Does not support
STEL alarm Does not support
Error Does not support
Table 22 'UPS' channel signals
Tip: The UPS signals are active in log 0 state. The idle, inactive state corresponds to logic level 1.
Figure 43 UPS
Description
Used for user channel description (channel name)
Selection of UPS signals for alarm 1 activation
Selection of UPS signals for alarm 2 activation
Selection of UPS signals for alarm 3 activation
Alarm 4 value
Enables channel display on the 'Transmitters' tab
Opens the output response matrix dialog to channel signals
53
User Service
 
 
 
 
 
 
 