Idrac Settings Utility - Dell E30S Series Owner's Manual

Option Description
Enables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from
Load Legacy
the video controller. Selecting Enabled in the operating system does not support UEFI video output
Video Option
standards. This field is available only for UEFI boot mode. You cannot set the option to Enabled if UEFI
ROM
Secure Boot mode is enabled.
Enables or disables In-System Characterization. This option is set to Disabled by default. The two
In-System
other options are Enabled and Enabled - No Reboot.
Characterization
When enabled, In-System Characterization (ISC) executes during POST upon detecting relevant changes
in system configuration to optimize system power and performance. ISC takes about 20 seconds to
execute, and system reset is needed for ISC results to be applied. The Enabled - No Reboot option
executes ISC and continues without applying ISC results until the next time system reset occurs. The
Enabled option executes ISC and forces an immediate system reset so that ISC results can be applied.
It takes the system longer to be ready due to the forced system reset. When disabled, ISC does not
execute.
Related references
Miscellaneous Settings on page 65
Related tasks
Viewing Miscellaneous Settings

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable
various iDRAC parameters by using the iDRAC settings utility.
Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
NOTE:
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at
idracmanuals.
Related concepts
Device Settings on page 67
Related references
System BIOS on page 42
Related tasks
Entering the iDRAC Settings utility
Changing the thermal settings
Entering the iDRAC Settings utility
Steps
1. Turn on or restart the managed system.
2. Press F2 during Power-on Self-test (POST).
3. On the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings screen is displayed.
Related references
iDRAC Settings utility on page 66
66 Pre-operating system management applications
The default setting for In-System Characterization is subject to change in future BIOS
NOTE:
releases.
on page 65
on page 66
on page 67
Dell.com/