Dell E30S Series Owner's Manual page 99

1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the #2 Phillips screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Disconnect the power and data cables from the hard drive(s) in the internal hard drive bay.
5. Remove the internal hard drive bay.
Steps
1. Insert the hard drive into the internal hard drive bay with the hard drive connector facing outward.
2. Secure the hard drive to the internal hard drive bay using the four screws.
When installing new hard drives into the internal hard drive bay, use the spare hard drive screws attached to the
NOTE:
hard drive bay.
Figure 45. Installing a cabled hard drive
Figure 46. Installing a cabled hard drive
a. spare screws
b. hard drive connector
c. hard drive
d. internal hard drive bay
e. screws (4)
Next steps
1. Install the internal hard drive bay into the chassis.
2. Connect the power and data cables to the hard drive(s).
3. Follow the procedure listed in the After working inside your system section.
4. Enter System Setup and ensure that the hard drive controller is enabled.
5. Exit System Setup and restart the system.
6. Install any software required for operating the hard drive as described in the documentation for the hard drive.
Installing and removing system components 99