Installing A Heat Sink - Dell E30S Series Owner's Manual

Figure 80. Installing a processor
1. socket-release lever 1
3. processor
5. processor shield
7. processor socket
Next steps
Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper
NOTE:
thermal conditions.
1. Install the heat sink.
2. If removed, reinstall the PCIe expansion card riser.
3. If disconnected, reconnect the cables to the expansion card(s).
4. Install the cooling shroud.
5. Follow the procedure listed in the After working inside your system.
6. While booting, press F2 to enter System Setup and verify that the processor information matches the new system
configuration.
7. Run the system diagnostics to verify that the new processor operates correctly.

Installing a heat sink

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
140 Installing and removing system components
2. pin–1 corner of the processor
4. slot (4)
6. socket-release lever 2
8. tab (4)