Internal Sd Card; Removing An (Optional) Internal Sd Card - Dell E30S Series Owner's Manual

2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the Internal Dual SD Module (IDSDM) connector on the system board.
2. Align the IDSDM with the IDSDM connector on the system board.
3. Push the IDSDM until it is firmly seated on the system board.
Figure 75. Installing the optional internal dual SD module
a. Internal Dual SD module
b. pull tab
c. IDSDM connector
Next steps
1. Install the SD card(s).
Temporarily label each SD card with its corresponding slot before removal. Replace the SD card(s) into the same
NOTE:
slots.
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.

Internal SD card

Removing an (optional) internal SD card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
Steps
1. Locate the SD card slot on the internal dual SD module and press the card to release it from the slot.
134 Installing and removing system components