System Feet; Removing The System Feet - Dell E30S Series Owner's Manual

2. Insert the bezel tabs into the bezel tab slots in the chassis.
3. Press the release latch, and push the bezel toward the system until the bezel locks into place.
4. Lock the bezel by using the key.
Figure 16. Installing the front bezel
a. bezel key
b. bezel
c. system

System feet

The system feet provide stability to the system in the tower mode.

Removing the system feet

Prerequisites
It is recommended that you remove the system feet only when you are converting the system from the tower mode
NOTE:
to the rack mode, or when you are replacing the system feet with the wheel assembly.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Turn the system feet inward.
4. Place the system on its side on a flat and stable surface.
Steps
Remove the screws that secure the system feet to the base of the tower.
Installing and removing system components 73