Toshiba MMD-AP0724H2UL Service Manual page 44

Changing of settings for Celsius display
• Push button if the unit stops.
ON / OFF
1
Procedure
Push simultaneously +
TEST
After a while, the display part flashes as shown right. Check the displayed CODE No. is [
• When the CODE No. is other than [
first step. (After pushing
(For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
2
Procedure
Every pushing button (button at left side), the indoor unit No. in the
UNIT LOUVER
group control is displayed in order. Select the indoor unit of which setup is
changed.
In this time, the position of the indoor unit of which setup is changed can be
confirmed because fan and louver of the selected indoor unit operate.
3
Procedure
1. Using temp. setup
TEMP.
33 33 33 33 33
(CODE No. [ ]: Fahrenheit display)
2. Using timer buttons, change the line address from [
TIME
0000 0000 0000
0000 0000
[ . ]
3. Push button. In this time, the setup finishes when the display
SET
changes from flashing to lighting.
4
Procedure
After check of the changed contents, push
When pushing button, the display disappears and the status becomes the usual stop status.
(When pushing button the operation from the remote controller is not accepted for approx. 1 minute.)
• If the operation from the remote controller is not accepted even 1 minute or more passed after pushing
button, it is considered that the address setup is incorrect. In this case, the automatic address must be again
set up.
When changing the settings from Celsius to Fahrenheit indication, follow to the reverse order of the above
procedure.
All manuals and user guides at all-guides.com
+ buttons for 4 seconds or more.
CL
SET
1 1 1 1 1 0 0 0 0 0
], push button to erase the display and repeat procedure from the
button, operation of the remote controller is not accepted for approx. 1 minute.)
4
5
6
1
buttons, specify CODE No. [
button. (Setup is determined.)
– 44 –
3
2
33 33 33 33 33
].
0001 0001 0001 0001 0001
] to
10 10 10 10 10
].
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
SETTING