Toshiba MMD-AP0724H2UL Service Manual page 40

How to change all indoor addresses from an arbitrary wired remote controller
(It is possible when setting has finished by automatic addresses.)
Contents: The indoor unit addresses in each identical refrigerant piping line can be changed from an
arbitrary wired remote controller.
Enter in address check/change mode and then change the address.
<Procedure> Carry out this procedure during stop of system.
1
Push the timer time button
First line 1 and CODE No.
2
Select line address using
3
Push the SET button.
• The address of the indoor unit connected to the
refrigerant piping of the selected outdoor unit is
displayed and the fan and the louver are on.
First the current indoor address is displayed.
(Line address is not displayed.)
4
button push up/down the indoor
TIME
address of the SET DATA.
The set data is changed to a new address.
5
Push button to determine the set data.
SET
6
Every pushing UNIT LOUVER
side), the indoor unit No. in the identical
piping is displayed one after the other.
• Only fan and louver of the selected indoor unit
start operation.
Repeat the Procedures
indoor addresses so that they are not duplicated.
7
Push SET button.
(All the indications of LCD go on.)
8
Push button and then the procedure
TEST
finishes.
All manuals and user guides at all-guides.com
+ simultaneously for 4 seconds or more.
TEST
AC AC AC AC AC
(Address Change) are displayed.
UNIT LOUVER / button.
SWING/FIX
button (button at left
4 6
to to change all the
– 40 –
TEMP.
TIMER SET
1
TIME
FILTER
RESET TEST SET CL SWING/FIX
3
Cancel of line selection
If the UNIT No. is not call up here, the outdoor unit
in that line does not exist.
CL
Push button to select a line again in the
2
Procedure .
TEMP.
TIMER SET
8
TIME
FILTER
Finish
RESET TEST SET CL SWING/FIX
5
<Operation procedure>
1 2 3 4
6 7 8
END
ON / OFF
FAN MODE
SAVE VENT
UNIT LOUVER
2
ON / OFF
FAN MODE
4
SAVE VENT
UNIT LOUVER
6
When you want to
complete the setting
7
5