Toshiba MMD-AP0724H2UL Service Manual page 31

8-3. Method to Set Indoor Unit Function DN Code
(When performing this task, be sure to use a wired remote control-
ler.)
<Procedure> To be performed only when system at rest
1
CL
SET
Push the + +
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in
group control.
Then the fan and louver of the selected indoor unit move.
2
Each time the "Select unit" side of the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan of the selected indoor unit move.
3
Use the TEMP. button to select the CODE No. (DN code) of the
desired function.
4
Use the button to select the desired SET DATA associated
with the selected function.
5
SET
Push the button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
SET
When the button is pushed, the system returns to normal off state.
All manuals and user guides at all-guides.com
buttons simultaneously and hold for at
UNIT LOUVER
button is pushed,
– 31 –
SET DATA 00 01
TEMP.
FILTER
RESET
3
2
.
3
.
10
CODE No.
SETTING TEST
UNIT No. 1-1
R.C. No.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
TEST SET CL SWING/FIX UNIT LOUVER
5 4
1 2
6