Using The Quick Connect Feature; Configuring Ethernet Communications - GE Multilin 369 Quick Start Manual

CHAPTER 3: USER INTERFACES
3.3.2

Using the Quick Connect Feature

3.3.3

Configuring Ethernet Communications

369 MOTOR MANAGEMENT RELAY – QUICKSTART GUIDE
The Quick Connect button can be used to establish a fast connection through the front
panel RS232 port of a 369 relay. The following window will appear when the Quick Connect
button is pressed:
As indicated by the window, the Quick Connect feature quickly connects the EnerVista 369
Setup software to a 369 front port with the following settings: 9600 baud, no parity, 8 bits,
1 stop bit. Select the PC communications port connected to the relay and press the
Connect button.
The EnerVista 369 Setup software will display a window indicating the status of
communications with the relay. When connected, a new Site called "Quick Connect" will
appear in the Site List window. The properties of this new site cannot be changed.
The 369 Site Device has now been configured via the Quick Connect feature for serial
communications. Proceed to Connecting to the Relay on page 3–25 to begin
communications.
Before starting, verify that the Ethernet cable is properly connected to the MultiNET device,
and that the MultiNET has been configured and properly connected to the relay. Refer to
the MultiNET manual for additional details on configuring the MultiNET to work with the
369.
CONNECTING ENERVISTA 369 SETUP TO THE RELAY
3–23