S11 369 Testing; Test Output Relays - GE Multilin 369 Quick Start Manual

CHAPTER 4: KEYPAD SETPOINTS
4.9

S11 369 Testing

4.9.1

Test Output Relays

TEST OUTPUT RELAYS
Note
369 MOTOR MANAGEMENT RELAY – QUICKSTART GUIDE
PATH: S11 369 TESTING TEST OUTPUT RELAYS
FORCE TRIP RELAY:
Disabled
FORCE TRIP RELAY
DURATION: Static
FORCE AUX1 RELAY:
Disabled
FORCE AUX1 RELAY
DURATION: Static
FORCE AUX2 RELAY:
Disabled
FORCE AUX2 RELAY:
DURATION: Static
FORCE ALARM RELAY:
Disabled
FORCE ALARM RELAY
DURATION: Static
The Test Output Relay feature provides a method of performing checks on all relay contact
outputs. This feature is not meant for control purposes during operation of the motor. For
control purposes, the force output relays functionality is used.
The forced state, if enabled (energized or de-energized), forces the selected relay into the
programmed state for as long as the programmed duration. After the programmed
duration expires, the forced state will return to disabled and relay operation will return to
normal. If the duration is programmed as Static, the forced state will remain in effect until
changed or disabled. If control power to the 369 is interrupted, any forced relay condition
will be removed.
When the relays in this feature are programmed to any value other than "Disabled", the In
Service LED on the front panel will turn on. The provides notification that the relay is not
currently operating in a normal condition.
The OUTPUT STATUS LED on the front display panel of 369 is lit when the output relay is in
energized state.
Range: Disabled, Energized, De-energized
Range: Static, 1 to 300 s in steps of 1
Range: Disabled, Energized, De-energized
Range: Static, 1 to 300 s in steps of 1
Range: Disabled, Energized, De-energized
Range: Static, 1 to 300 s in steps of 1
Range: Disabled, Energized, De-energized
Range: Static, 1 to 300 s in steps of 1
S11 369 TESTING
4–55