Vibe Monitor - uAvionix AV-30-E Service Manual

The factory setting for non-magnetometer equipped units is NONE, and the
factory setting for magnetometer equipped units is MAG1. Leave the AID
Mode set to the default, unless otherwise direct by uAvionix Support.
To change, push the center knob and rotate to select your choice of
magnetometer aiding and then push the center button to confirm your
choice.

9.3 VIBE MONITOR

The Vibration Monitor can be used, with assistance from uAvionix support,
to troubleshoot installation issues or unusual aircraft conditions.
The monitor can be accessed by selecting "VIBE MONITOR" from the
Installation Menu. Follow the procedure in Section 9 to access the
Installation Menu. Rotate the center knob until "VIBE MONITOR" is
displayed. Push the center button to start monitoring current and peak
vibrations in the accelerometer and gyroscopic sensors.
Service Bulletin 21
UAV-1005757-001 Rev A