Rear-View Camera Connection - Caraudio-Systems r.LiNK RL-FD79-TF Manual

6. When the radio powers up, turn the radio ON and select the FM Radio source. This step
simply helps in verifying the interface is corresponding with the radio.
7. While listening to the FM Source, place dip switch number "2" to the "ON" position on the
RLC-FO01-A module connected on the 125kb 8-Pin connector. Leave the RLC-FO01-A module
connected on the 500kb 8-Pin connector alone. The screen will power off and begin to reset.
8. Wait for the interface to reboot, the progress bar will show percentage completed. This
process may take up to 1 minute. Once completed the FM Radio Source will continue to play
as it was before the reboot.
9. With the Rear-View Camera disconnected, start the vehicle and place the vehicle into the
reverse gear. The radio display will prompt you with an error message of "Camera
Unavailable". This verifies the coding was a success!

3. Rear-view camera connection

Rear-view camera
+12V rear-view camera
output (max. 500mA)
1
Connect the video RCA of the rear-view camera to the female RCA connector (RVC
input) of the TV-FS54 harness.
Connect the white cable from the 125kb 8-Pin connector of harness TV-FS54 to the
2
camera power supply (+12V, max 500mA). The white cable gets power when reverse
gear is engaged. By leaving the rear camera level the power is switch off again
Note: Only compatible with NTSC-cameras.
Version 01.03.2019
2
1
128kb
Harness
TV-FS54
RL-FD79-TF