Interface for activation of factory rear-view camera input compatible with bmw vehicles with professional ccc navigation systems and factory pdc behind (6 pages)
Compatible with audi navi plus and vw mfd1 navigation systems (4:3) (6 pages)
Summary of Contents for Caraudio-Systems RL-MZ72D
Page 1
RL-MZ72D Rear-view camera input compatible with 7” touchscreen Mazda Connect Infotainment system Delivery contents Take down the SW-version and HW-version of the interface boxes, AC-VDIF and store this manual for support purposes. HW______________ RLC-MZ72D SW______________ Legal Information Changes/updates of the vehicle’s software can cause malfunctions of the interface. We offer free software-updates for our interfaces for one year after purchase.
2. With the dash trim out of the way, remove gently pulling towards you with a panel the AC vent by gently pulling it out. Use a remover. Avoid removing it completely as it will panel removal tool if necessary. be difficult to put back in. Version 24.11.2017 RL-MZ72D...
Page 3
GREEN wire (Video signal ground) into PIN 15. Make sure that the pins are inserted far enough into the connector to lock in place. Press down the terminal lock to lock pins in place. Version 24.11.2017 RL-MZ72D...
10. Tap the wires from the RLC-MZ72D module following wires: harness to the OEM connector wires RED CAN wire according to the diagram below. We WHITE CAN wire recommend soldering for a secure BLACK Ground wire connection. YELLOW +12V Wiring diagram: Version 24.11.2017 RL-MZ72D...
OE MZ72D harness. screen. 15. Radio und Armaturenleisten wieder einbauen. Technical Support Caraudio-Systems Vertriebs GmbH Manufacturer / Distributor In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim Email: support@caraudio-systems.de Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ®...
Need help?
Do you have a question about the RL-MZ72D and is the answer not in the manual?
Questions and answers