Table of Contents
Advertisement
1.5.
Connection schema
2. Installation
Switch off ignition and disconnect the vehicle's battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
1. Remove the factory display to gain access to the factory 54-Pin connector.
Located behind the display, not the radio. Remove the factory 54-Pin connector.
2. Using the provided 54-Pin harness, mate both sides of the harness. To the factory harness
side and back into the radio side.
3. Connect the one RLC-FO01-A module to the 125kb 8-Pin connector and the other RLC-
FO01-A module to the 500kb 8-Pin connector on the provided harness (note: the RLC-FO01-
A modules are identical). Make sure all your connections are firmly inserted into each
module.
4. After connecting the modules, set dip switch number "6" to the "ON" position on both
modules. Make sure to match both modules for dip switch number 6.
5. With the harness and interface modules properly connected, turn the ignition to the "ON"
position. For Push-Start vehicles, simply press the button once to place the vehicle "ON".
Version 01.03.2019
RL-FD79-TF
Advertisement
Table of Contents
