Starting Treatment; Routine Use; Connecting The Tubing; Adjusting The Tubing - 3B G3 Series User Manual

Luna G3 BPAP 25A (G3 B25A) User Manual MID-97/v1.0

12.8 Starting Treatment

Connect the device to a power outlet, press the Start / Stop Button and
the device will start delivering air.
WARNINGS!
• Be sure to follow your physician's instructions on adjusting the settings! To order any
accessories not included with this device, contact your equipment supplier.
• DO NOT connect any ancillary equipment to this device unless recommended by
3B MEDICAL or your physician. If you suffer from chest discomfort, shortness of breath,
stomach bloating, or severe headache when using the device, contact your
physician or qualified medical personnel immediately.

13. Routine Use

13.1 Connecting the Tubing

Connect the power cord, power adapter, and tubing properly according to the
instructions in the First Time Setup (Chapter 12). Connect the mask and headgear
according to the user manual for the mask.
CAUTION!
• Before each use, examine the tubing for any damage or debris. If necessary,
clean the tubing to remove the debris. Replace any damaged tubing. Make sure
that the mask does not leak.

13.2 Adjusting the Tubing

Lie down on your bed, and adjust the tubing so it is free to move if you turn during
sleep. Adjust the mask and headgear until you have a comfortable fit and no
airflow leaks around the mask.

13.3 Turning on the Airflow

Press the Start / Stop Button to turn on the airflow. The screen will display
treatment pressure and other information.

13.4 Heating the Water

Pay attention to the number next to the icon when using the humidifier. The
number indicate the On / Off state of the humidifier. It is off when the number next
to the icon is 0.
CAUTION!
• Observe the water level of the water chamber before using the humidifier. Make
sure there is sufficient water in the water chamber, avoid heating the device with
an empty water chamber.
20 / 48