Inserting The Sd Card (Only For The Device That Equipped With Sd Card) - 3B G3 Series User Manual

Luna G3 BPAP 25A (G3 B25A) User Manual MID-97/v1.0
WARNINGS!
• Connect the oxygen tube to the oxygen inlet of the mask.
• The oxygen supply must comply with the local regulations for medical oxygen.
• Turn on the device before turning on the oxygen. Turn off the oxygen before
turning off the device. Explanation of Warning: When the device is turned off, but
the oxygen flow still exists, oxygen may accumulate within the device's enclosure
and pose a fire hazard. Turning off the oxygen before turning off the device will
prevent oxygen accumulation in the device and reduce the risk of fire. This warning
applies to all CPAP devices.
• Oxygen supports combustion. Keep the device and the oxygen container away
from heat, open flames, any oily substances, or other sources of ignition. DO NOT
smoke in the area near G3 BPAP 25A System or the oxygen container.
• Sources of oxygen should be located more than 1 m from the device.
• When using oxygen with this system, a Pressure Valve must be placed in-line with
the patient circuit between the device and the oxygen source. The pressure valve
helps prevent the backflow of oxygen from the patient circuit into the device when
the unit is off. Failure to use the pressure valve could result in a fire hazard.
• Do not connect the device to an unregulated or high pressure oxygen source. The
pressure of oxygen source should not exceed the work pressure of the device.
12.7 Inserting the SD Card (Only for the device that
equipped with SD card)
Insert the SD card into the SD Card Slot, as shown in Fig. 12-11.
SD Card Slot
SD Card
Fig. 12-11
If the SD card is inserted correctly, a symbol indicating correct insertion will
appear in the Main Interface on the screen of the device.
If the SD card is inserted incorrectly, a symbol indicating incorrect insertion will
appear in the Main Interface on the screen of the device.
CAUTIONS!
• If the SD card is not inserted, there will not be a symbol appear in the Main
Interface on the screen of the device.
• To avoid data loss or any damage to the SD card, the SD card should only be
removed after the device stops delivering air.
19 / 48