Connecting To Power Cord Locker - 3B G3 Series User Manual

Luna G3 BPAP 25A (G3 B25A) User Manual
WARNINGS!
• The device is powered on for use when the power cord and power adapter is
connected. The Knob
• Use of the device at an AC voltage beyond the stated range (see Section 5 "AC
Power Consumption") may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
• Inspect the power cord often for any signs of damage. Replace a damaged cord
immediately.
IMPORTANT TIPS!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
• To remove AC power, disconnect the power cord from the power outlet.

12.4 Connecting to Power Cord Locker

(1) Insert the power cord locker into the device, as shown in Fig. 12-5, and then
rotated to the left for assembly to the device.
(2) Open the power cord locker, plug the power cord to the power supply, and
press the locker downward to fix the power cord into the power port.
The function of the locker is to prevent the power cord being displaced from the
power port.
turns the blower On / Off.
DC Inlet
Power Cord Locker
Fig. 12-5
Power Adapter
Power Cord
Fig. 12-6
16 / 48
DC Inlet
Power Cord Locker
MID-97/v1.0