Chapter 3 Jumper Configuration - Renesas Y-RH850-F1X-176PIN-PB-T1-V3 User Manual

RH850/F1x-176pin PiggyBack board V3

Chapter 3 Jumper Configuration

F1L
JP1 closed
JP2 open
JP3 open
JP4 closed
JP5 open
JP6 open
JP7 1-2 closed
JP7 2-3 open
JP8 1-2 closed
JP8 2-3 open
JP9 1-2 closed
JP9 2-3 open
JP10 1-2 closed
JP10 2-3 open
JP21 1-2 closed
JP21 2-3 open
JP17 1-2 closed
JP17 2-3 open
JP24 1-2 open
JP24 2-3 open
1)
JP29 1-2 open
1)
JP29 2-3 open
1)
JP30 1-2 open
1)
JP30 2-3 open
1)
Note available on the EESS-0400-135-01 board version.
R20UT3931ED0120 Rev. 1.20
2017-10-20
The function of the board can be configured via jumpers. This chapter describes
the standard configuration, i.e. jumper setting for the intended devices. For the
supported function of the used device, please refer to the corresponding HW
user's manual.
The table has the following meaning:

x-y: Connect the pins x and y; valid for 3-pin jumpers (e.g. JP24)
The pin #1 can be identified by a small circle in the vicinity of the jumper
Depending on the used device a configuration of several jumpers is required. The
detailed configuration is shown below:
F1M F1H
open open
closed closed
open open
open open
closed closed
open open
closed closed
open open
closed closed
open open
closed closed
open open
closed closed
open open
open open
closed closed
open open
closed closed
open Either
open
open open
open open
open open
open open
F1K F1KM-S4
closed
open
open closed
closed
open
open closed
closed
open closed
closed
open closed
closed
open closed
closed
open closed
Either
Or closed
Either
Or closed
open
Or open
open
open
open
open
Y-RH850-F1X-176PIN-PB-T1-V3
Function
open
Selection of Pin 114:
open
P9_6, VSS or REGVCC
open
Selection of Pin 113:
open
P9_5, REGVCC or VSS
open
Selection of Pin 73:
P1_6 or ISOVCL
open
Selection of Pin 72:
P1_7 or VSS
open
Selection of Pin 14:
P11_14 or VSS
open
Selection of Pin 73:
P11_13 or ISOVCL
open
Selection of PWGA34:
Either from P9_5 or P0_11
open
Selection of PWGA35:
Either P9_6 or P0_6
open
Selection of ETH0RXERR:
Either P11_14 or P11_15
open
Either
Selection of CAN7RX:
Either P20_4 or P10_14
Or
Either
Selection of CAN7TX:
Either P20_5 or P10_13
Or
8