F1KH-D8 324pin PiggyBack board
2.2
2.3
R20UT4326ED0100 Rev.1.0
2018-05-30
Mounting of the device
The board is designed for use with the following devices:
•
RH850/F1KH-D8 324pin
The device must be placed inside the socket IC1. To insert the device, press
down the lid, align the #A1 pin of the device to the #A1pin of the socket, insert
the device inside the socket and release the lid.
For details regarding the operation of the microcontroller, refer to the
RH850/F1KH, RH850/F1KM User's Manual.
Jumper configuration
The function of the board can be configured via jumpers. This chapter describes
the standard configuration, i.e. jumper setting for the intended devices. For the
supported function of the used device, please refer to the corresponding HW
user's manual.
The table has the following meaning:
•
x-y: Connect the pins x and y; valid for 3-pin jumpers (e.g. JP10)
The pin #1 can be identified by a small circle in the vicinity of the
jumper
The jumper settings also are shown in this picture:
Figure 3 – Jumper setting overview
Y-RH850-F1X-324PIN-PB-T1-V1
7