Section 3.6: The Opus Control For Gt1175 Units; Section 3.7: Navigate With The Rotary Dial; Section 3.8: Io Terminal Strips - Nabco GT1175 Wiring And Programming Manual

GT1175 Slide Door Opus Control Wiring and Programming Manual
P/N C-00391
SECTION 3.6: The Opus Control for GT1175 Units
Note: The Hold Close feature is enabled when the LCD screen is OFF, or disabled when the LCD screen is LIT.
DN 1328
1 CN3 I/O Terminal Strip
2 CN5 Relay Output Terminal Strip
3 CN4 CAN Bus Communication
4 - Rotary Dial
SECTION 3.7: Navigate with the Rotary Dial
Push down on the Rotary Dial:
X
1. Long push (2) seconds to gain access to LCD Category Screens.
2. Short push under (2) seconds to access Sub-level screens, and to selected/unselect menu items.
3. Long push (2) seconds to go back to Level Two or Level One screens.
4. Long push (2) seconds to go back to Main screen.
• Clockwise: To scroll forward through screens and programming options.
Turn the Rotary Dial (2) clicks to advance through each menu item:
X
• Counterclockwise: To scroll backward through screens and programming options.
DN 2429
SECTION 3.8: IO Terminal strips
1 12VDC +12VDC
2 GND Common for 12V and signals
3 61 Interior Activation
4 62 Exterior Activation/Programmable Input
5 6B Holding Beam
6 SWL Default setting: Sidelite Safety
Rev 27 & Later: Input is programmable
7 Out1 Sensor Monitoring (Programmable Output)
Closes to Common
6 of 31
5 - LCD Screen
6 CN2 Motor Connector
7 CN1 Power Connector
8 - Fuse
UNIT SPECIFICATIONS
11
Type:
Status:
Error:
Ac v on: IN EXT
Rotary Dial
Posi on:
Other:
20
I/O Terminal Strips (1 thru 14)
10
GT1175 Opus Slide
GT710 Swing
Slow Closing
Fully Closed
-----
> > > > > > > > >
BA 6B SWL
Push and Hold Dial
Go to Se ng Mode
12
8 BA Breakout
9 SQ Sequential activation (signal to open, signal to close)
10 H Reduced Open (Programmable Input)
11 M0 Mode 0 One way when
connected to Common
12 M1 Mode 1 Night when connected
to Common
13 Out 2 Aux. Output 2, Programmable output, closes to GND
14 GND Common for all above signals
www.NabcoEntrances.com
9 - Ground Screw (Slide Door only)
10 - Power Switch (Slide Door only)
11 - Bracket (Slide Door only)
LCD Screen
Figure 1 The Rotary Dial
Hold Open when
both M0 and M1
connected to
Common
Rev 8-11-21