Chapter 1: Safety - Nabco GT1175 Wiring And Programming Manual

www.NabcoEntrances.com
Rev. 8-11-21
CHAPTER 1: SAFETY
SECTION 1.1: Warning Labels
Warning labels are universal and used to alert an individual of potential harm to one's self or to others. The following warning labels
are listed in a hierarchy order that defines the most potential danger first, and the least potential danger last.
Indicates potentially dangerous situations. Danger is used when there is a hazardous situation
DANGER
where there is a high probability of severe injury or death. It should not be considered for
property damage unless personal injury risk is present.
Indicates a hazardous situation which has some probability of severe injury. It should not be
WARNING
considered for property damage unless personal injury risk is present.
Indicates a hazardous situation which may result in a minor injury. Caution should not be
CAUTION
used when there is a possibility of serious injury. Caution should not be considered for
property damage accidents unless a personal injury risk is present.
Attention: A situation where material could be damaged or the function impaired.
Indicates a statement of company policy as the message relates to the personal safety or protection of
Notice:
property. Notice should not be used when there is a hazardous situation or personal risk
Note: Indicates important information that provides further instruction.
SECTION 1.2: General Safety Recommendations
Disconnect all power to the junction box prior to making any electrical connections. Failure to
DANGER
do so may result in serious personal or fatal injury. When uncertain whether power supply is
disconnected, always verify using a voltmeter.
Do not place finger or uninsulated tools inside the electrical controller. Touching wires or
DANGER
other parts inside the enclosure may cause electrical shock, serious injury or death.
Read, study and understand the installation and operating instructions contained in or
WARNING
referenced in this manual before operating. If you do not understand the instruction, ask a
qualified technician. Failure to do so may result in bodily injury or property damage and will
nullify all warranties.
The Ground wire from the Opus Control 120 VAC Harness, and the Incoming 120 VAC Ground
CAUTION
wire must be connected to the Ground screw located within the Swing door Header.
All electrical troubleshooting or service must be performed by trained, qualified electrical
CAUTION
technicians and comply with all applicable governing agency codes.
Do Not touch other parts of the Opus Control board with a screwdriver or anything else metal.
CAUTION
Damage to electrical circuitry may occur.
If the door appears broken or does not seem to work correctly, it should be immediately
CAUTION
removed from service until repairs can be carried out or a qualified service technician is
contacted for corrective action.
Notice: This manual, the owner's manual and all other associated manuals must be given to and retained
by the purchasing facility or end user.
Notice: Wiring must meet all local, state, federal or other governing agency codes.
GT1175 Slide Door Opus Control Wiring and Programming Manual
P/N C-00391
.
3 of 31