Section 8.6: History Setting; Section 8.7: Test Open - Nabco GT1175 Wiring And Programming Manual

GT1175 Slide Door Opus Control Wiring and Programming Manual
P/N C-00391
Parameter Terminal
61 Monitoring N/A
62 Monitoring N/A
6B Monitoring N/A
SWL Monitoring N/A
* If monitoring is enabled for any input, a sensor must be connected to that input that is capable of monitoring. That sensor's
input must then be connected to an Opus output programmed for monitoring. If this is not done, errors will occur resulting in
the door not operating until the problem is fixed.
* Monitoring settings are "OFF" by default except when used as "1175 Opus Slide", in which case standard settings have
monitoring enabled.
SECTION 8.6: History Setting
Parameter
Operation Cnt
Open Recycle Cnt
Close Recycle Cnt
Latest Recycle Position
SECTION 8.7: Test Open
16 of 31
Default
Active
Active
Active
Not Active
► Indicates number of Door open cycles.
► Updated every 100 door cycles.
Indicates number of times the Door reversed direction during Opening cycle after sensing:
► An object was struck.
► The amount of friction that surpassed the recycle sensitivity setting.
Indicates number of times the Door reversed direction during Closing cycle after sensing:
► An object was struck.
► The amount of friction that surpassed the Recycle Sensitivity Setting.
► Indicates the last recycle position during opening and closing.
► For swing doors it displays the approximate angle from closed at recycle. For slide doors it displays
the position in inches from closed.
Tests Open/Close door cycle while ignoring Safety Signals.
Input Setting
Range
► Active
► Not Active
► Active
► Not Active
► Active
► Not Active
► Active
► Not Active
History Data
Description
<= Test Open =>
www.NabcoEntrances.com
Description
Sensor monitoring function *
Sensor monitoring function *
Sensor monitoring function *
Sensor monitoring function *
Rev 8-11-21