Chapter 2: Scope; Section 2.1: To The Installer; Section 2.2: Objective; Section 2.3: Request A User Name/Password To Gain Access Into The "Mynabco" Portal - Nabco GT1175 Wiring And Programming Manual

GT1175 Slide Door Opus Control Wiring and Programming Manual
P/N C-00391
CHAPTER 2: SCOPE
SECTION 2.1: To the Installer
The purpose of this manual is to familiarize the installer with the proper installation and operation of this system. It is essential that
this equipment be properly installed and operational before the door is used by the public. It is the installer's responsibility to inspect
the operation of the entrance system to be sure it complies with any applicable standards. In the United States, ANSI Standard 156.10
(Used to cover Full Energy doors) and ANSI Standard 156.19 (Used to cover Low Energy doors) apply. Other local standards or codes
may apply. Use them in addition to the ANSI standards.
If after troubleshooting a problem, a satisfactory solution cannot be achieved, please call Nabco Entrances at 1-877-622-2694
between 8 am – 4:30 pm Central time for additional assistance. This manual offers step by step instructions. Do Not take shortcuts.
SECTION 2.2: Objective
The Opus Control is designed to be installed within new Swing, Sliding, and Folding Door Units, plus:
Existing swing, sliding, and folding doors using Analog, Magnum, or U01-U19 controls (works with encoders or microswitches).
X
Existing sliding doors using U01-U19 controls. Contact Customer Service at 1-888-679-3319 to purchase Retrofit kits.
X
SECTION 2.3: Request a User Name/Password to gain access into the "myNABCO" portal
To gain access into the "myNABCO" portal, the User must first have an assigned User Name and Password. To request a User Name
and Password, the following must be done:
1. Open the NABCO Website: www.nabcoentrances.com
2. Enter the "myNABCO" portal → Request Access → Fill out the Request Access Form → Click onto Register
a. A User Name and Password will be emailed back to the requestor.
SECTION 2.4: QR Code Links
Android Phone Instruction to Scan QR Code
1. Google to download QR Scanner. Install.
Downloading a QR Scanner by an Android Phone may vary.
2. Place phone in front of QR Code. Scan.
Associated Videos
Opus - Navigating Top Level Screens
Opus - Using the Rotary Dial
CHAPTER 3: GETTING STARTED
SECTION 3.1: Features
Specification
Power Close
Back Check Angle Adjustment
Latch Check Angle Adjustment
Built In Sequencer
4 of 31
QR Code
Built-in
► 5 to 35 degrees from Full Open position
► 10 to 40 degrees from Full Closed position
Can activate Electric Locks
I-Phone Instruction to Scan QR Code
1. Click on Camera icon.
2. Place phone in front of QR Code. Scan.
Associated Videos
Opus - Wiring and Configuring for Electric Locks
Opus - Connecting Mode Switches
Description
► Used with Encoder Motor only.
► Used with Encoder Motor only.
► Electric Strikes
► Electric Latch Retracted Panic Devices
www.NabcoEntrances.com
Rev 8-11-21
QR Code