Chapter 2: Getting Started; Section 2A: AboutTheU30MicroprocessorControl; Section 2B: ElectricalSpecifications - Nabco GT 1175 Installation Manual

ElectricalInstallationManualU-30"D"Control
Part #C-00121
CHAPTER 2: GETTING STARTED
Section 2a: About the U30 Microprocessor Control
The U30 Microprocessor Control is utilized on all GT-1175 Slide Door systems to control
numerous operating characteristics that include (but not limited to): speed, recycling sensitivity
and reduced opening width.
Note: The U30 Microprocessor Control will need to be programmed after installation is complete.
The U30 Microprocessor Control is also utilized to output power to accessories and/or auxiliary
equipment such as:
► Sensors ►
► Modules ►
There are times when the U30 Microprocessor Control is not utilized to output power because
some accessories and/or auxiliary equipment are shipped with it's own dedicated power supply.
Section 2b: Electrical Specifications
All Wiring Diagrams included within this manual, reflect typical primary and secondary circuits
that are installed at the NABCO Factory. The low voltage Reed Switch (12 VDC) and Sensor(s) are
also installed complete with connector housings at the NABCO Factory.
Note: NABCO factory utilizes Underwriters Laboratories (UL) recognized component wire, terminals and
connector housings to manufacture GT-1175 Slide Door systems.
Table 2-1 Sensors
Acusensor 3 14-8902-3
Sensor Part Number
IXIO 14-14264
Optex i-one 14-13036
Table 2-2 Modules
Optex Beam
Module
CP/RX Radio
Control Receiver
2-6
Infrared
Function
Infrared + Microwave
Infrared
14-9710-01 Beam & Control
Part Number Function
24-11467 RF Signal Transmission 12 to 24 AC or DC
12 to 24 AC or DC
Power Source
12 to 24 VAC
12 to 35 VDC +/-10%
12 to 24 VAC or 12 to 30 VDC 130mA
12 to 24 AC or DC
Power Source
www.NabcoEntrances.com
Rev. 8-25-16
100mA
Current Consumption
100mA
(ea.unit) at 12VDC
160mA
Current Consumption
(ea.unit) at 12VDC
50mA
GettingStarted