Section 4.4 Cancel Passcode Or Reset To Default; Section 4.5 Level Three And Four: Setting Category And Menu Items; Chapter 5: Stroke Learning - Nabco GT1175 Wiring And Programming Manual

www.NabcoEntrances.com
Rev. 8-11-21
SECTION 4.4 Cancel Passcode or Reset to Default
LEVEL 2
Passcode
Reset to Default Set
Stroke Learning
Yes No
Reset to Default Set
0 0 4
If you don't know
the passcode,
Rotate
Keep Pushing Switch,
Dial Return to Normal mode
SECTION 4.5 Level Three and Four: Setting Category and Menu Items
LEVEL 2
Go to Se ng menu
Stroke Learning
DN 1716
CHAPTER 5: STROKE LEARNING
11
Type: 1
Status:
Error:
Ac va on: IN EXT
Posi on:
Other:
Push and Hold Dial
Go to Se ng Mode
DN 2314
20
Note: Prior to stroke learn the door must always be in the closed position and status should read fully closed.
Stroke Learning is used to measure from Fully Closed to Fully Open points in effort to determine where Check Points should happen.
SECTION 5.1 Stroke Learning (YES)
1. Go to the Opus Control. From the Unit Specs Screen, press down on the Rotary Dial until the next Screen is displayed.
2. Turn the Rotary Dial to highlight (YES) under (Stroke Learning).
a. Do not press the Rotary Dial at this time.
3. Fully Open the Slide door.
4. Go back to the Opus Control. Briefly press down on the Rotary Dial.
a. The Control will check to see if the Door is fully Open → then slowly Close
If Handing of Door is wrong, messages after the Stroke Learning Cycle will display: "Wrong Hand! Restroke". If this event occurs
SECTION 5.2 Error Message
one of two things are indicated:
The wrong Operator Type is selected - or - the wrong Handing is selected.
X
If the wrong Handing is selected:
Enter the proper settings within the Base Setting Category screens.
X
Reset to Default Set
0
If you don't know
Short
the passcode,
Keep Pushing Switch,
Push
Return to Normal mode
Reset to Default Set
0 0 4 4
If you don't know
Short the passcode,
Keep Pushing Switch,
Push
Return to Normal mode
LEVEL 3
Passcode
Se ng Category
Base Se ng
Short Movement Se ng
Op onal Se ng
Push
Yes No
Output Se ng
Input Se ng
History Data
Long Push
10
GT1175 Opus Slide
Fully Closed Slow Closing
-----
> > > > > > > > >
BA 6B SWL
12
GT1175 Slide Door Opus Control Wiring and Programming Manual
Reset to Default Set
0 0
If you don't know
Short
the passcode,
Keep Pushing Switch,
Push
Return to Normal mode
Reset to Default Set
0 0 4 5
If you don't know
Rotate
the passcode,
Keep Pushing Switch,
Dial
Return to Normal mode
Rotate
Dial
Long Push
Passcode
Go to Se ng menu
Stroke Learning
Yes No
Yes
Reset to Default Set
0 0 0
If you don't know
Short
the passcode,
Keep Pushing Switch,
Push
Return to Normal mode
Correct PassCode!
0 0 4 5
If you don't know
Short
the password,
Keep Pushing Switch,
Push
Return to Normal mode
LEVEL 4
Low Energy or Full
Low Full
Wrong Hand!
Restroke
OR
Clear Yes
Figure 6 Stroke Learning
P/N C-00391
DN 1712
No
9 of 31