General Safety Recommendations - Nabco GT 1175 Installation Manual

With u30 microprocessor controller

Hide thumbs Also See for GT 1175:

Installation manual (62 pages)

Quick setup manual (53 pages)

Wiring and programming manual (31 pages)

Table Of Contents

Table of Contents

ElectricalInstallationManualU-30"D"Control

Part #C-00121

Do not install, operate or service this product unless you have read and understand

WARNING

the General Safety Recommendations, Warning Labels, contained in this manual.

Failure to do so may result in bodily injury, or property damage.

Read, study and understand the installation and operating instructions contained in,

WARNING

or referenced in this manual before operating. If you do not understand the instruction,

ask a qualified technician. Failure to do so may result in bodily injury, or property

damage and will nullify all warranties.

Disconnect all power to the junction box prior to making any electrical connections.

DANGER

Failure to do so may result in seriouc personal or fatal injury. When uncertain whether

power supply is disconnected, always verify using a voltmeter.

Do not place finger or uninsulated tools inside the electrical controller. Touching wires

DANGER

or other parts inside the enclosure may cause electrical shock, serious injury or death.

The Ground wire from the Magnum IV Control 120 VAC Harness, and the Incoming 120

CAUTION

VAC Ground wire must be connected to the Ground screw located within the Swing

door Header.

If the door appears broken or does not seem to work correctly, it should be

CAUTION

immediately removed from service until repairs can be carried out or a qualified

service technician is contacted for corrective action.

Notice:

This manual, the owner's manual and all other associated manuals must be given to and

retained by the purchasing facility or end user.

Notice:

Wiring must meet all local, state, federal or other governing agency codes.

Notice:

All electrical troublshooting or service must be performed by qualified

electrical technicians and must comply with all applicable governing

agency codes.

Note:

All Adjustments must be made with a small screwdriver. Do Not use a pencil.

Note:

Do Not take shortcuts.